Measured terminal impedances of several commercial loudspeaker systems are developed into their equivalent electrical circuits by using the Brune network synthesis method. The synthesized circuits accurately describe the properties of the loud as seen by the amplifier feeding the loudspeaker system. A group of nonsinusoidal audio signal sequences, which cause the loudspeaker to draw momentary currents considerably in excess of what could be expected from the rated terminal impedance, is identified using computerized network analysis methods. The maximum value of peak cvrrent reported for a commercial loudspeaker is 6.6 times larger than that of an 8-(symbol) resistor. The current peaks typically last a few hundred microseconds or are caused by the simultaneous parallel excitation of several drivers of multiway system, by the summation of cancellation currents originating from the energy stored in the mechanical and electrical reactances of the circuit, and by impedance transformation effects in the crossover network. The results imply that for short periods of time an amplifier should be able to drive, with full output voltage swing and without appreciable distortion, loads equal to a resistor of 1 (symbol).
Click to purchase paper as a non-member or you can login as an AES member to see more options.
No AES members have commented on this paper yet.
To be notified of new comments on this paper you can
subscribe to this RSS feed.
Forum users should login to see additional options.
If you are not yet an AES member and have something important to say about this paper then we urge you to join the AES today and make your voice heard. You can join online today by clicking here.
