In This Section
Perceptual Effects of Dynamic Range Compression in Popular Music Recordings - January 2014
Accurate Calculation of Radiation and Diffraction from Loudspeaker Enclosures at Low Frequency - June 2013
New Measurement Techniques for Portable Listening Devices: Technical Report - October 2013
AES Convention Papers Forum
Design of Vented Boxes Using Current Feedback Filters
A current feedback arrangement for a loudspeaker system that can be tuned to provide a pre-determined frequency-response shape over a fairly wide and continuous range of box volumes is discussed. A conventional high-pass filter only allows the system to be tuned to give a particular frequency-response shape if the box volume is correct. The traditional arrangement is either a flat response amplifer, a passive filter between the amplifier and loudspeaker, or an active filter before the amplifier. This paper discusses an alternative arrangement where current feedback and filter provide the desired amplifier output impedance and voltage transfer function characteristics. These interact directly with the complex load-impedance of the loudspeaker. Practical realizations of the current feedback implementations are presented.
No AES members have commented on this paper yet.
Subscribe to this discussion
Start a discussion!
If you are not yet an AES member and have something important to say about this paper then we urge you to join the AES today and make your voice heard. You can join online today by clicking here.