The traditional solution for controlling microphone wind response (foam windshield) is of limited benefit in minature applications. The use of ECM and MEMS type microphones is typically associated with DSP-type solutions to reduce the unwanted output from air mass flow. Such solutions vary widely in their effectiveness. The situation is compounded by the range of techniques in current use to evaluate microphone wind response. This paper discusses the essential elements necessary for consistent microphone wind measurements and proposes a standard measurement technique that will be of use to all developers and manufacturers concerned with controlling microphone wind noise. Practical implementation of the technique and results obtained for a range of microphones are presented.

Authors: Busbridge, Simon; Herman, David
Affiliations: AudioGravity Ltd., Brighton, UK; University of Brighton, Brighton, UK(See document for exact affiliation information.)
AES Convention: 127 (October 2009) Paper Number: 7889
Publication Date: October 1, 2009
Subject: Consumer Audio

Click to purchase paper as a non-member or you can login as an AES member to see more options.

No AES members have commented on this paper yet.

Subscribe to this discussion

To be notified of new comments on this paper you can subscribe to this RSS feed. Forum users should login to see additional options.

Start a discussion!

If you would like to start a discussion about this paper and are an AES member then you can login here:
Username:
Password:

If you are not yet an AES member and have something important to say about this paper then we urge you to join the AES today and make your voice heard. You can join online today by clicking here.